Slight Seconds SE5A
At VMC, absolute quality is highly important to us.
We thoroughly check each sheet of cut parts for unwanted artefacts from the laser cutting process and occasionally we find rejects.
What's wrong with them? Sometimes there is a slightly burned edge, sometimes the laser hasn't fully cut through a part.
It's all very trivial for the average modeller who can fashion the odd part from the balsa sheet offcuts.
It doesn't feel right to simply waste these parts by throwing them away, so instead we are offering them to those of you out there who don't mind having a few questionable parts and would rather have a big discount.
At a Glance
- Power System - Rubber Free Flight
- Wingspan - 16" (406mm)
- Approximate AUW - 25g
- Difficulty - Beginner
Four balsa sheets with precise laser cut parts and strip wood (some or all of the sheets may have defects).
PVA glue for building the wooden frames.
One 150mm diameter plastic propeller.
One pre-bent motor hook and shaft.
Small piece of acetate sheet for the screen
Three low friction plastic nose bushings - one for the propeller and two for the undercarriage wheels.
Piano wire for the main undercarriage and tail wheel legs.
One motor peg (cocktail stick or toothpick).
Two plastic drinking straws (approximately 5mm in diameter).
Rubber motor strip.
Tissue to cover the model.
Parts reference sheets (W), full size summary plan sheets (X), scheme diagram sheet (Y) and scheme markings (Z) printed on lightweight paper.
SE5A ORIGINAL INSTRUCTION BOOKLET COPY
Download a spare copy of the instruction booklet included in your kit here:SE5A Instruction Booklet
SE5A MARKINGS SHEET
Click the link below to download a pdf version of the markings sheet included in the SE5A kit.
The markings sheet should fit onto a single A4 page and may be printed onto your own paper or decal transfer sheet.
SE5A PATTERNS SHEET
Click the link below to download a pdf version of the patterns for acetate and paper/card parts originally drawn on the plan.
This will save you from having to cut into your beautiful plan!
Built, filmed, edited and produced by the amazing Rob Brennan.
The illustrated instructions below are available for you to view, download or print out for free.
They do not replace the instruction book but can be used alongside it.
We hope you find them useful!
MAIN PARTS & FRAMES BUILDING SCHEDULE
The Centre Section [Download]
The Main Wing Panels [Download]
Building The Jigs [Download]
The Tail Plane (Stabiliser) [Download]
The Fin & Rudder [Download]
The Fuselage [Download]
The Nose Block [Download]
The Wheels, Undercarriage & Tail Skid [Download]
Rocker Covers, Exhaust & Wind Screen [Download]
The Fin, Rudder, Tail Plane & Skid [Download]
The Wings [Download]
The Fuselage [Download]
- 16" (406mm)